Juniper ACX2000 Configuration Guide

Example: Disabling a PoE Interface on ACX2000 Routers
This example shows how to disable PoE on all interfaces or on a specific interface.
•
Requirements on page 149
•
Overview on page 149
•
Configuration on page 149
•
Verification on page 149
Requirements
Before you begin:
•
Configure PoE on all interfaces. See “Example: Configuring PoE on ACX2000 Routers”
on page 144.
Overview
In this example, you disable PoE on all interfaces and on a specific interface, which in
this case is ge-0/1/3.
Configuration
Step-by-Step
Procedure
• Disable PoE on all interfaces.
[edit]
user@host# set poe interface all disable
• Disable PoE on a specific interface.
[edit]
user@host# set poe interface ge-0/1/3 disable
Verification
To verify the configuration is working properly, enter the show poe interface command.
user@host> show poe interface
Interface Admin Oper Max Priority Power Class
status status power consumption
ge-0/1/3 Disabled Disabled 32.0W Low 0.0W 0
ge-0/1/7 Disabled Disabled 32.0W Low 0.0W 0
user@host> show poe interface ge-0/1/3
PoE interface status:
PoE interface : ge-0/1/3
Administrative status : Disabled
Operational status : Disabled
Power limit on the interface : 32.0 W
Priority : Low
149Copyright © 2017, Juniper Networks, Inc.
Chapter 4: Configuring Interfaces and Chassis

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English