Juniper ACX2000

Table 60: Standard MIBs supported by Junos OS (continued)
PlatformsExceptionsStandard MIB
M Series and T SeriesUnsupported tables and objects:
•
dsx3FarEndConfigTable
•
dsx3FarEndCurrentTable
•
dsx3FarEndIntervalTable
•
dsx3FarEndTotalTable
•
dsx3FracTable
RFC 3896, Definitions of Managed
Objects for the DS3/E3 Interface Type
M Series, MX Series, and T SeriesDescribes MIB objects in the following
tables for managing tunnels of any type
over IPv4 and IPv6 networks:
•
tunnelIfTable—Provides information
about the tunnels known to a router.
•
tunnelInetConfigTable—Assists
dynamic creation of tunnels and
provides mapping from end-point
addresses to the current interface
index value.
NOTE: Junos OS supports MAX-ACCESS
of read-only for all the MIB objects in
tunnelIfTable and tunnelInetConfigTable
tables.
RFC 4087, IP Tunnel MIB
Only MX240, MX480, and MX960
routers, and EX2200 and EX3300
switches
Unsupported tables and objects:
•
entityLogicalGroup table
•
entPhysicalMfgDate and
entPhysicalUris objects in
entityPhysical2Group table
•
entLPMappingTable and
entPhysicalContainsTable in
entityMappingGroup table
•
entityNotoficationsGroup table
RFC 4133, Entity MIB
MX Series, EX Series, and M Series and
T Series
•
Supports 802.1D STP(1998)
•
Supported subtrees and objects:
•
dot1dStp subtree is supported on
MX Series 3D Universal Edge
Routers.
•
dot1dTpFdbAddress,
dot1dTpFdbPort, and
dot1dTpFdbStatus objects from the
dot1dTpFdbTable of the dot1dTp
subtree are supported on EX Series
Ethernet Switches.
•
dot1dTpLearnedEntryDiscards and
dot1dTpAgingTime objects are
supported on M Series and T Series
routers.
RFC 4188, Definitions of Managed Objects
for Bridges
979Copyright © 2017, Juniper Networks, Inc.
Chapter 29: Understanding Network Management