show services rpm rfc2544-benchmarking
Syntax show services rpm rfc2544-benchmarking
<aborted-tests (test-id [test-id] | brief | detail)>
<active-tests (test-id [test-id] | brief | detail)>
<completed-tests (test-id [test-id] | brief | detail)>
<summary>
Release Information Command introduced in Junos OS Release 12.3X52 for ACX Series routers.
Command introduced in Junos OS Release 13.3R1 for MX104 3D Universal Edge Routers.
Description Display information about the results of each category or state of the RFC 2544-based
benchmarking test, such as aborted tests, active tests, and completed tests, for each
real-time performance monitoring (RPM) instance. You can view the results of each test
state for all of the configured test IDs or for a specific test ID. Also, you can display
statistics about the total number of tests of each state for a high-level, quick analysis.
The values in the output displayed vary, depending on the state in which the test is passing
through, when you issue the command.
You can view the test results of multiple test IDs at the same time by entering the IDs in
a single command. If you enter multiple test ID values, you must separate each number
with a space.
Options none—Display test results for all categories.
aborted-tests—(Optional) Display the list of tests that were aborted or stopped. This list
includes tests that failed due to various error conditions and tests that you terminated
by entering the test service rpm rfc2544-benchmarking test test-name stop command.
The Status field in the output specifies the reason for the termination of the test.
active-tests—(Optional) Display the results of the set of tests that are currently running.
brief | detail—Display the specified level of output.
completed-tests—(Optional) Display the results of the set of tests that were successfully
completed. A completed test is one that passes through all the test steps or states
specified in RFC 2544. A test that is marked as completed after it went through all
the states from the beginning to the end can still be reported as a failed test. For
example, a failed test can be a test that sends the desired number of packets, but
does not receive the frames back from the other end.
summary—(Optional) Display summary output.
test-id test-id—Display test results for the specified unique identifier of the test.
Required Privilege
Level
view
Copyright © 2017, Juniper Networks, Inc.3156
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
