To Next Page

To Previous Page

show isis route

List of Syntax Syntax on page 2702

Syntax (EX Series Switches and QFX Series) on page 2702

Syntax show isis route

<logical-system (all | logical-system-name)>

Syntax (EX Series

Switches and QFX

Series)

show isis route

Release Information Command introduced before Junos OS Release 7.4.

Command introduced in Junos OS Release 9.0 for EX Series switches.

Command introduced in Junos OS Release 12.1 for the QFX Series.

Command introduced in Junos OS Release 14.1X53-D20 for the OCX Series.

Description Display the routes in the IS-IS routing table.

Options none—Display all routes in the IS-IS routing table for all supported address families for

all routing instances.

destination—(Optional) Destination address for the route.

inet | inet6—(Optional) Display inet (IPv4) or inet6 (IPv6) routes, respectively.

instance instance-name—(Optional) Display routes for the specified routing instance

only.

logical-system (all | logical-system-name)—(Optional) Perform this operation on all

logical systems or on a particular logical system.

topology (ipv4-multicast | ipv6-multicast | ipv6-unicast | unicast)—(Optional) Display

routes for the specified topology only, or use unicast to display information, if

available, for both IPv4 and IPv6 unicast topologies.

Required Privilege

Level

view

List of Sample Output show isis route logical-system on page 2703

show isis route floodgroup on page 2703

show isis route (CLNS) on page 2704

show isis route on page 2704

ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Configuration Guide

Other manuals for Juniper ACX2000