reflect-etype (RFC 2544 Benchmarking)
Syntax reflect-etype ethertype-value;
Hierarchy Level [edit services rpm rfc2544-benchmarkingtests test-name test-name]
Release Information Statement introduced in Junos OS Release 12.3X53 for ACX Series routers.
Statement introduced in Junos OS Release 15.1 for MX104 3D Universal Edge routers.
Description Specify the EtherType to be used for reflection of the test frames. EtherType is a two-octet
field in an Ethernet frame that defines the protocol in the frame payload. This statement
is valid only if you configure the test mode to be a reflector. If you do not configure this
statement, all EtherTypes are reflected.
Options ethertype-value—Identifier for the EtherType. The EtherType value appears in the Ethernet
type field of the packet. It specifies the protocol being transported in the Ethernet
frame. For instance, the EtherType for IPv4 is 0x0800. So, if you specify the value
as 2048, IPv4 packets are reflected.
Range: 1 through 65,535
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• RFC2544-Based Benchmarking Tests Overview
• Supported RFC2544-Based Benchmarking Statements on MX104 Routers
• Configuring an RFC 2544-Based Benchmarking Test
Copyright © 2017, Juniper Networks, Inc.1696
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
