Juniper ACX2000

NOTE: ACX Series routers do not support family inet6 on MLPPP interfaces.
NOTE: The effective family MTU might be different from the MTU value
specified for MLPPP configurations, because it is adjusted downward by the
remote MRRU’s constraints. The remote MRRU configuration is not supported
on M120 routers.
Related
Documentation
Link and Multilink Services Overview•
• Configuring Encapsulation for Multilink and Link Services Logical Interfaces on page 514
• Configuring the Drop Timeout Period on Multilink and Link Services Logical Interfaces
• Limiting Packet Payload Size on Multilink and Link Services Logical Interfaces
• Configuring the Minimum Number of Active Links on Multilink and Link Services Logical
Interfaces on page 515
Configuring the Sequence Header Format on Multilink and Link Services Logical
Interfaces
NOTE: Only MLPPP is supported on ACX Series routers. MLFR is not supported
on ACX Series routers.
For MLPPP, the sequence header format is set to 24 bits by default. You can configure
an alternative value of 12 bits, but 24 bits is considered the more robust value for most
networks.
To configure a different sequence header value, include the short-sequence statement:
short-sequence;
You can include this statement at the following hierarchy levels:
•
[edit interfaces interface-name unit logical-unit-number]
•
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number]
For MLFR FRF.15, the sequence header format is set to 24 bits by default. This is the only
valid option.
Related
Documentation
Link and Multilink Services Overview•
• Configuring the Drop Timeout Period on Multilink and Link Services Logical Interfaces
• Limiting Packet Payload Size on Multilink and Link Services Logical Interfaces
517Copyright © 2017, Juniper Networks, Inc.
Chapter 17: Configuring MLPPP