show multicast snooping next-hops
Syntax show multicast snooping next-hops
<brief | detail>
<identifier next-hop-ID>
<inet>
<inet6>
<logical-system logical-system-name>
Release Information Command introduced in Junos OS Release 11.2.
Description Display information about the IP multicast snooping next-hops.
Options brief | detail—(Optional) Display the specified level of output.
inet—(Optional) Display information for IPv4 multicast next hops only. If a family is not
specified, both IPv4 and IPv6 results will be shown.
inet6—(Optional) Display information for IPv6 multicast next hops only. If a family is not
specified, both IPv4 and IPv6 results will be shown.
logical-system logical-system-name—(Optional) Display information about a particular
logical system, or type ’all’.
Required Privilege
Level
view
List of Sample Output show multicast snooping next-hops on page 2753
show multicast snooping next-hops (IGMP snooping enabled on a VPLS) on page 2753
Output Fields Table 174 on page 2751 describes the output fields for the show multicast snooping next-hops
command. Output fields are listed in the approximate order in which they appear.
Table 174: show multicast snooping next-hops Output Fields
Field DescriptionField Name
Protocol family for which multicast snooping next hops are displayed: INET or INET6.Family
Number of cache entries that are using this next hop.Refcount
Kernel reference count for the next hop.KRefcount
Interface names associated with each multicast next-hop ID.Downstream interface
2751Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
