restart chassis-control
List of Syntax Syntax on page 1800
Syntax (MX Series Routers) on page 1800
Syntax (PTX Series) on page 1800
Syntax restart chassis-control
<lcc number | sfc number>
<gracefully | immediately | soft>
Syntax (MX Series
Routers)
restart chassis-control
<gracefully | immediately | soft>
Syntax (PTX Series) restart chassis-control
<gracefully | immediately | soft>
Release Information Command introduced before JUNOS Release 7.4.
Command introduced in Junos OS Release 12.3 for MX2020 3D Universal Edge Routers.
Command introduced in Junos OS Release 12.3 for MX2010 3D Universal Edge Routers.
Command introduced in Junos OS Release 17.2 for MX2008 3D Universal Edge Routers.
Command introduced in Junos OS Release 17.3 for MX10003 3D Universal Edge Routers.
Description Restart the chassis management process.
NOTE: When GRES is configured and the restart chassis-control command
is executed on a TX Matrix Plus router with 3D SIBs, we cannot ascertain
which Routing Engine becomes a master. This is due to the chassisd restart.
The chassis process or chassid is responsible for maintaining and retaining
mastership and when it is restarted, the new chassisd is processed based on
the router load. This results in one of the Routing Engines being made master.
Options lcc number—(Routing matrix only) (Optional) Restart the software process for a specific
T640 routing node that is connected to a TX Matrix platform. Replace number with
a value from 0 through 3.
sfc number—(TX Matrix Plus routers only) (Optional) Restart the software process on
the TX Matrix Plus router (or switch-fabric chassis). Replace number with 0.
gracefully—(Optional) Restart the software process.
immediately—(Optional) Immediately restart the software process.
Copyright © 2017, Juniper Networks, Inc.1800
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
