skip-arp-iteration (RFC 2544 Benchmarking)
Syntax skip-arp-iteration;
Hierarchy Level [edit services rpm rfc2544-benchmarkingtests test-name test-name]
Release Information Statement introduced in Junos OS Release 12.3X53 for ACX Series routers.
Description Disable the Address Resolution Protocol (ARP) test iteration for IPv4 or inet services
during a benchmarking test. This parameter is valid only for an inet family. An ARP test
iteration is a 3-second iteration that is run for all inet tests. The results of this iteration
are disregarded in the test result calculations. The ARP test iteration is performed by
sending test frames for 3 seconds to ensure that all devices on the path to destination
add ARP entries in the cache of the corresponding devices. This parameter is not
applicable for CCC and bridge families.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• RFC 2544-Based Benchmarking Tests Overview on page 1335
• Configuring RFC 2544-Based Benchmarking Tests on page 1341
• rfc2544-benchmarking on page 1698
1723Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements
To Next Page
Loading...
Need help?
General
