• Configuring Service Sets to Be Applied to Services Interfaces on page 1031
• Configuring Queuing and Scheduling on Inline Services Interface on page 1040
Service Filter Actions
ACX Series support different sets of terminating and nonterminating actions that you
can configure in a service filter term.
NOTE: Service filters do not support the next term action.
Table 66 on page 1039 describes the terminating actions you can configure in a service
filter term.
Table 66: Terminating Actions for Service Filters
Protocol
FamiliesDescription
Terminating
Action
inetDirect the packet to service processing.service
Table 67 on page 1039 describes the nonterminating actions you can configure in a service
filter term.
Table 67: Nonterminating Actions for Service Filters
Protocol
FamiliesDescription
Nonterminating
Action
inetAccept the packet.accept
inetCount the packet in the named counter.count counter-name
inetLog the packet header information in a buffer within the Packet Forwarding Engine.
You can access this information by issuing the show firewall log command at the
command-line interface (CLI).
log
inetPort-mirror the packet based on the specified family.port-mirror
Related
Documentation
Enabling Inline Services Interface on ACX Series on page 1008•
• Understanding Service Sets on page 1028
• Service Filters in ACX Series on page 1035
• Guidelines for Applying Service Filters on page 1036
• Service Filter Match Conditions for IPv4 Traffic on page 1038
• Configuring Service Sets for Network Address Translation on page 1030
1039Copyright © 2017, Juniper Networks, Inc.
Chapter 31: Configuring Network Address Translation (NAT) and Stateful Firewall Services
To Next Page
Loading...
Need help?
General
