Juniper ACX2000 Configuration Guide

Table 3: Protocols and Applications Supported by ACX Series Routers (continued)
ACX500ACX5096ACX5048ACX4000ACX2100ACX2000ACX1100ACX1000Protocol or Application
12.3X54
–D20
(Indoor)
12.3X54
–D25
(Outdoor)
15.1X54
–D20
15.1X54
–D20
12.3x51
-D10
12.2R212.212.2R212.2Standard SNMP MIBs
12.3X54
–D20
(Indoor)
12.3X54
–D25
(Outdoor)
15.1X54
–D20
15.1X54
–D20
12.3x51
-D10
12.2R212.212.2R212.2Juniper Networks
enterprise-specific MIBs
Related
Documentation
ACX Series Universal Access Routers•
Hardware Architecture Overview
Juniper Networks routing platforms are made up of two basic routing components:
•
Routing Engine—The Routing Engine controls the routing updates and system
management.
•
Packet Forwarding Engine (PFE)—The Packet Forwarding Engine performs Layer 2
and Layer 3 packet switching, route lookups, and packet forwarding.
From a system administration perspective, you install the software onto the Routing
Engine and during the installation, the appropriate software is forwarded to other
components as necessary. Most Routing Engines include a CompactFlash card that
stores Junos OS. On M Series Multiservice Edge Routers; MX240, MX480, and MX960
3D Universal Edge Routers; T Series Core Routers; and TX Matrix routers, the system also
includes a hard disk or solid-state drive (SSD) that acts as a backup boot drive. PTX
Series Packet Transport Routers and the TX Matrix Plus router include a solid-state drive
as a backup boot drive.
NOTE: The MX80 router is a single-board router with a built-in Routing Engine
and single Packet Forwarding Engine. On an MX80 router, Junos OS is stored
on dual, internal NAND flash devices. These devices provide the same
functionality as a CompactFlash card and hard disk or solid-state drive (SSD).
21Copyright © 2017, Juniper Networks, Inc.
Chapter 1: ACX Series Universal Access Router Overview

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English