Juniper ACX2000

signal-type (BITS Interfaces)
Syntax signal-type (2048KHZ | e1 | t1) {
e1-options {
framing (g704 | g704-no-cro4);
}
t1-options {
framing (esf | sf);
}
}
Hierarchy Level [edit chassis synchronization interfaces bits]
Release Information Statement introduced in Junos OS Release 12.3 for ACX Series Routers.
Description Configure the input and output signal type to the same value for the building-integrated
timing supply (BITS) interface.
Options 2048khz—Configure the BITS interface to output or accept as input the 2.048 MHz square
wave.
e1—Configure the BITS interface to output or accept as input the E1 framed signal.
t1—Configure the BITS interface to output or accept as input the T1 framed signal.
The remaining statements are explained separately. See CLI Explorer.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• External Clock Synchronization Overview for ACX Series Routers on page 226
• Configuring External Clock Synchronization for ACX Series Routers on page 228
• Synchronous Ethernet Overview
• show chassis synchronization on page 2386
1719Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements