no-local-switching (VPLS)
Syntax no-local-switching;
Hierarchy Level [edit bridge-domains bridge-domain-name]
Release Information Statement introduced in Junos OS Release 8.5.
Description Prevent CE devices from communicating directly with each other. If the no-local-switching
statement is configured, frames arriving on a CE interface are sent to a VPLS edge (VE)
device or core-facing interfaces only.
NOTE: (MX80, MX104, and the 16x10GE MPC, MPC1, or MPC2 on MX240,
MX480, MX960, MX2010, and MX2020 only) If you configure the
no-local-switching command at the [edit bridge-domains bridge-domain-name]
hierarchy level, it might not prevent multicast traffic from being forwarded
between the CE-facing interfaces of the bridge domain. Broadcast, unknown
unicast, and known multicast traffic does not exhibit this behavior.
Required Privilege
Level
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Related
Documentation
• Configuring VPLS and Integrated Routing and Bridging
Copyright © 2017, Juniper Networks, Inc.1638
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
