tunnel-services (Chassis)
Syntax tunnel-services {
bandwidth bandwidth-value;
tunnel-only;
}
Hierarchy Level [edit chassis fpc slot-number pic number]
Release Information Statement introduced in Junos OS Release 8.2.
Statement introduced in Junos OS Release 12.3X54 for ACX Series routers.
Description For MX Series 3D Universal Edge Routers, configure the amount of bandwidth for tunnel
services.
For ACX Series routers, configure the amount of bandwidth for tunnel services. Only
bandwidths of 1 Gbps and 10 Gbps are supported for ACX routers.
For M7i, M10i, M120, M320, T Series and TX Matrix routers with IQ2 PICs and IQ2E PICs,
configure support for per unit scheduling for GRE tunnels. You can specify the IQ2 and
IQ2E PICs to work exclusively in tunnel mode or as a regular PIC. The default setting uses
IQ2 and IQ2E PICs as a regular PIC. If you do not configure the tunnel-only option, the IQ2
and IQ2 PICs operate as regular PICs. For M7i, M10i, M120, M320, T Series and TX Matrix
routers with IQ2 PICs and IQ2E PICs, you can use the tunnel-only option to specify that
an IQ2 or IQ2E PIC work in tunnel mode only.
NOTE: Bandwidth rates of 20 gigabits per second and 40 gigabits per second
require use of an MX Series router with the 100-Gigabit Ethernet Modular
Port Concentrator (MPC) and the 100-Gigabit CFP MIC.
NOTE: On MX80 routers and MX Series routers with Trio-based FPCs, when
ingress queuing is enabled for a PIC, tunnel services and inline services are
not supported on the same PIC.
Options tunnel–only (Optional)—For M7i, M10i, M120, M320, T Series and TX Matrix routers with
IQ2 PICs and IQ2E PICs, specify that an IQ2 or IQ2E PIC work in tunnel mode only.
The remaining statements are explained separately. See CLI Explorer.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
1765Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements
To Next Page
Loading...
Need help?
General
