To Next Page

To Previous Page

static (Protocols Layer 2 Circuit)

Syntax static {

incoming-label label;

outgoing-label label;

send-oam;

}

Hierarchy Level [edit logical-systems logical-system-name l2circuit neighbor address interface

interface-name],

[edit logical-systems logical-system-name l2circuit neighbor address interface interface-name

backup-neighbor neighbor],

[edit protocols l2circuit neighbor address interface interface-name],

[edit protocols l2circuit neighbor address interface interface-name backup-neighbor neighbor]

Release Information Statement introduced in Junos OS Release 9.5.

Statement introduced in Junos OS Release 12.1X48 for PTX Series routers.

Statement introduced in Junos OS Release 12.2 for ACX Series routers.

Description Configures static Layer 2 circuit pseudowires. Static pseudowires are designed for

networks that do not support LDP or do not have LDP enabled. You configure a static

pseudowire by configuring static values for the in and out labels needed to enable a

pseudowire connection.

Options incoming-label—(Optional for PTX Series Packet Transport Routers only) Configure the

Layer 2 circuit incoming static pseudowire label.

Range: 1000000 through 1048575

outgoing-label—(Optional for PTX Series Packet Transport Routers only) Configure the

Layer 2 circuit outgoing static pseudowire label.

Range: 16 through 1048575

The remaining statement is explained separately. See CLI Explorer.

Required Privilege

Level

routing—To view this statement in the configuration.

routing-control—To add this statement to the configuration.

Documentation

• Configuring Static Layer 2 Circuits

ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Configuration Guide

Other manuals for Juniper ACX2000