speed (10-Gigabit Ethernet)
Syntax speed (1g | 10g);
Hierarchy Level [edit interfaces xe-fpc/pic/port],
Release Information Statement introduced in Junos OS Release 12.3X54 for ACX Series Universal Access
Routers.
Description Configure the interface speed for the 10-Gigabit Ethernet interface (xe) when dual-rate
SFP+ optic modules are plugged into the port. The default speed mode of 1GE is used
when you plug in a dual-rate SFP+ module. You must use set interfaces xe-x/y/z speed
(1g | 10g) statement to configure 1GE or 10GE speed mode only for dual-rate SFP+ optic
modules. You must not use the speed (1g | 10g) option with other optics of fixed speed
plugged into the xe port.
Options You can specify the speed as either 10g (10 Gbps), or1g (1 Gbps).
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• Configuring the Interface Speed
• Dual-Rate SFP+ Optic Modules for ACX Series Routers on page 134
Copyright © 2017, Juniper Networks, Inc.1728
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
