Juniper ACX2000 Configuration Guide

Managed Objects for jnxSoamLmCurrentStatsTable
The jnxSoamLmCurrentStatsTable, whose object identifier is {jnxSoamPmLmObjects 3},
contains the jnxSoamLmCurrentStatsEntry that signifies the Ethernet loss measurement
(ETH-LM) historical statistical details. Each jnxSoamLmCurrentStatsEntry, whose object
identifier is {jnxSoamLmCurrentStatsTable 1}, contains the objects listed in the following
table.
The jnxSoamLmCurrentStatsTable contains the results for the current Measurement
Interval in a SOAM Loss Measurement session gathered during the interval indicated by
iterator counts. A row in this table is created automatically by the SNMP Agent when the
Loss Measurement session is configured. Each row in the table represents the current
statistics for a Loss Measurement session for the defined MEP. This table uses four
indices. The first three indices are the indices of the Maintenance Domain, MaNet, and
MEP tables. The fourth index is the specific LM session on the selected MEP. There may
be more than one LM session per MEP. The main use case for this is to allow multiple
CoS instances to be operating simultaneously for a MEP. The objects in this table apply
regardless of the value of jnxSoamLmCfgType unless otherwise specified in the object
description. Except for jnxSoamLmCurrentStatsIndex, jnxSoamLmCurrentStatsStartTime,
jnxSoamLmCurrentStatsElapsedTime and jnxSoamLmCurrentStatsSuspect, each object
in this table applies only if the corresponding bit is set in
jnxSoamLmCfgMeasurementEnable. The objects in this table do not need to be persistent
upon reboot or restart of a device.
Table 93: jnxSoamLmCurrentStatsTable
DescriptionObject IDObject
Specifies the index for the Measurement
Interval within this PM session. This value
will become the value for
jnxSoamLmHistoryStatsIndex once the
Measurement Interval is completed.
Measurement Interval indexes are
assigned sequentially by the SNMP
Agent. The first Measurement Interval
that occurs after the session is started is
assigned index 1.
jnxSoamLmCurrentStatsEntry 1jnxSoamLmCurrentStatsIndex
Specifies the time at which the
Measurement Interval started.
jnxSoamLmCurrentStatsEntry 2jnxSoamLmCurrentStatsStartTime
Specifies the length of time for which the
Measurement Interval has been running,
in 0.01 seconds.
jnxSoamLmCurrentStatsEntry 3jnxSoamLmCurrentStatsElapsedTime
1185Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English