show lldp local-information
Syntax show lldp local-information
Release Information Command introduced in Junos OS Release 9.6.
Description Display local Link Layer Discovery Protocol (LLDP) information.
Options This command has no options.
Required Privilege
Level
view
List of Sample Output show lldp local-information(Management Information Address Subtype is
IPv4) on page 2735
show lldp local-information(Management Information Address Subtype is
IPv6) on page 2735
Output Fields Table 169 on page 2733 describes the output fields for the show lldp local-information
command. Output fields are listed in the approximate order in which they appear.
Table 169: show lldp local-information Output Fields
Field DescriptionField Name
Information that follows pertains to the local system.LLDP Local
Information details
List of chassis identifiers for local information.Chassis ID
Local system name reported by LLDP.System name
Local system description reported by LLDP.System descr
Capabilities (such as Bridge or Router) that are Supported or Enabled by system
on the interface.
SystemCapabilities
Listed by Interface Name, Address Subtype (such as ipv4, ipv6), Address (such
as 192.168.168.229, 1fd::1a10), Interface Number, and Interface Numbering Subtype.
Management
Information
List of local interfaces.
For information about interface names, see Interface Naming Overview. For
information about interface names for TX Matrix routers, see TX Matrix Router
Chassis and Interface Names. For information about FPC numbering on TX Matrix
routers, see Routing Matrix with a TX Matrix Router FPC Numbering.
Interface Name
Name of the ae interface to which the interface belongsParent Interface
List of local interface identifiers.Interface ID
2733Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
