EasyManuals Logo

Juniper ACX2000 Configuration Guide

Juniper ACX2000
3270 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #793 background imageLoading...
Page #793 background image
[edit protocols pcep]
user@PCC# commit
commit complete
Related
Documentation
Support of the Path Computation Element Protocol for RSVP-TE Overview on page 692•
• Example: Configuring Path Computation Element Protocol for MPLS RSVP-TE with
Support of PCE-Initiated LSPs on page 721
• pcep on page 1657
Example: Configuring Path Computation Element Protocol for MPLS RSVP-TE with Support
for PCE-Controlled Point-to-Multipoint LSPs
This example shows how to configure the Path Computation Client (PCC) with the
capability of reporting point-to-multipoint traffic engineered label-switched paths (TE
LSPs) to a Path Computation Element (PCE).
•
Requirements on page 735
•
Overview on page 735
•
Configuration on page 736
•
Verification on page 746
Requirements
This example uses the following hardware and software components:
•
Three routers that can be a combination of ACX Series, M Series, MX Series, or T Series
routers.
•
One virtual machine configured with Virtual Route Reflector (VRR) feature.
•
A TCP connection to an external stateful PCE from the VRR.
•
Junos OS Release 16.1 or later running on the PCC.
Before you begin:
•
Configure the device interfaces.
•
Configure MPLS and RSVP-TE.
•
Configure OSPF or any other IGP protocol.
Overview
After a PCEP session is established between a PCE and a PCC, the PCC reports all the
LSPs in the system to the PCE for LSP state synchronization. This includes PCC-controlled,
PCE-delegated, and PCE-initiated point-to-point LSPs. Starting with Junos OS Release
15.1F6 and 16.1R1, this capability is extended to report point-to-multipoint LSPs as well.
By default, PCE control of point-to-multipoint LSPs is not supported on a PCC. To add
this capability, include the p2mp-lsp-report-capability statement at the [edit protocols
pcep pce pce-name] or [edit protocols pcep pce-group group-id] hierarchy levels.
735Copyright © 2017, Juniper Networks, Inc.
Chapter 23: Configuring Path Computation Element Protocol (PCEP)

Table of Contents

Other manuals for Juniper ACX2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper ACX2000 and is the answer not in the manual?

Juniper ACX2000 Specifications

General IconGeneral
BrandJuniper
ModelACX2000
CategoryNetwork Router
LanguageEnglish

Related product manuals