EasyManuals Logo

Juniper ACX2000 Configuration Guide

Juniper ACX2000
3270 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1284 background imageLoading...
Page #1284 background image
Table 100: jnxSoamDmThresholdCfgTable (continued)
DescriptionObject IDObject
Sets the average two-way IFDV threshold
value that will be used to determine if a
threshold notification is generated.
jnxSoamDLmThresholdCfgEntry 4jnxSoamDmThresholdCfgAvgIfdvTwoWayThreshold
Specifies the status of the ETH-DM
threshold configuration row status. The
writable columns in a row cannot be
changed if the row is active. All columns
are to have a valid value before a row can
be activated.
jnxSoamDmThresholdCfgEntry 5jnxSoamDmThresholdCfgRowStatus
Managed Objects for jnxSoamPmNotificationObj Table
The jnxSoamPmNotificationObj table, whose object identifier is {jnxSoamPmMibObjects
5}, contains the objects listed in the following table.
Table 101: jjnxSoamPmNotificationObj Table
DescriptionObject IDObject
Contains the time and date at the time
that the notification event is detected,
not the time of the notification
generation. This object is used only for
notifications. The mechanism to set and
keep current the date and time is not
specified.
jnxSoamPmNotificationObj 1jnxSoamPmNotificationObjDateAndTime
Denotes the object identifier of the object
that caused the generation of the
notification from the
jnxSoamLmThresholdEntry or
jnxSoamDmThresholdEntry. This object
is only used for the notification.
jnxSoamPmNotificationObj 2
Denotes the configured threshold value
of the object that caused the generation
of the notification. This object is only used
for the notification.
jnxSoamPmNotificationObj 3jnxSoamPmNotificationObjThresholdConfig
Denotes the measured value of the object
at the time of the generation of the
Notification, from the
jnxSoamLmMeasuredStatsTable,
jnxSoamLmCurrentStatsTable,
jnxSoamDmMeasuredStatsTable or
jnxSoamDmCurrentStatsTable. This
object is only used for the notification.
jnxSoamPmNotificationObj 4jnxSoamPmNotificationObjThresholdValue
Copyright © 2017, Juniper Networks, Inc.1226
ACX Series Universal Access Router Configuration Guide

Table of Contents

Other manuals for Juniper ACX2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper ACX2000 and is the answer not in the manual?

Juniper ACX2000 Specifications

General IconGeneral
BrandJuniper
ModelACX2000
CategoryNetwork Router
LanguageEnglish

Related product manuals