Juniper ACX2000

cesopsn-options
Syntax cesopsn-options {
excessive-packet-loss-rate {
sample-period milliseconds;
threshold percentile;
}
idle-pattern pattern;
jitter-buffer-latency milliseconds;
jitter-buffer-packets packets;
packetization-latency microseconds;
}
Hierarchy Level [edit interfaces interface-name]
Release Information Statement introduced in Junos OS Release 12.2R1.
Statement introduced in Junos OS Release 12.3R1 for ACX Series Universal Access Routers.
Description Set Circuit Emulation Service over Packet-Switched Network (CESoPSN) protocol
options.
Options You can configure the following CESoPSN options:
• idle-pattern—An 8-bit hexadecimal pattern to replace TDM data in a lost packet (from
0 through 255).
• jitter-buffer-packets—Number of packets in the jitter buffer (from 1 through 64 packets).
• jitter-buffer-latency—Time delay in the jitter buffer (from 1 through 1000 milliseconds).
• packetization-latency—Time required to create packets (from 1000 through 8000
microseconds).
• excessive-packet-loss-rate—Set packet loss options. The option is sample-period.
• sample-period—Time required to calculate the excessive packet loss rate (from 1000
through 65,535 milliseconds).
• threshold—Percentile designating the threshold of excessive packet loss rate (1–100
percent).
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• Setting the CESoPSN Options on page 216
1459Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements