show route terse
List of Syntax Syntax on page 3153
Syntax (EX Series Switches) on page 3153
Syntax show route terse
<logical-system (all | logical-system-name)>
Syntax (EX Series
Switches)
show route terse
Release Information Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
Description Display a high-level summary of the routes in the routing table.
NOTE: For BGP routes, the show route terse command displays the local
preference attribute and MED instead of the metric1 and metric2 values. This
is mostly due to historical reasons.
To display the metric1 and metric2 value of a BGP route, use the show route
extensive command.
Options none—Display a high-level summary of the routes in the routing table.
logical-system (all | logical-system-name)—(Optional) Perform this operation on all
logical systems or on a particular logical system.
Required Privilege
Level
view
List of Sample Output show route terse on page 3155
Output Fields Table 230 on page 3153 describes the output fields for the show route terse command.
Output fields are listed in the approximate order in which they appear.
Table 230: show route terse Output Fields
Field DescriptionField Name
Name of the routing table (for example, inet.0).routing-table-name
Number of destinations for which there are routes in the routing table.number destinations
3153Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
