Juniper ACX2000 Configuration Guide

Table 230: show route terse Output Fields (continued)
Field DescriptionField Name
Number of routes in the routing table and total number of routes in the following states:
• active (routes that are active)
• holddown (routes that are in the pending state before being declared inactive)
• hidden (routes that are not used because of a routing policy)
number routes
Key for the state of the route:
• +—A plus sign indicates the active route, which is the route installed from the routing table into the
forwarding table.
• - —A hyphen indicates the last active route.
• *—An asterisk indicates that the route is both the active and the last active route. An asterisk before
a to line indicates the best subpath to the route.
route key
Active route. An asterisk (*) indicates this is the active route.A
Validation status of the route:
• ?—Not evaluated. Indicates that the route was not learned through BGP.
• I—Invalid. Indicates that the prefix is found, but either the corresponding AS received from the EBGP
peer is not the AS that appears in the database, or the prefix length in the BGP update message is
longer than the maximum length permitted in the database.
• N—Unknown. Indicates that the prefix is not among the prefixes or prefix ranges in the database.
• V—Valid. Indicates that the prefix and autonomous system pair are found in the database.
V
Destination of the route.Destination
Protocol through which the route was learned:
• A—Aggregate
• B—BGP
• C—CCC
• D—Direct
• G—GMPLS
• I—IS-IS
• L—L2CKT, L2VPN, LDP, Local
• K—Kernel
• M—MPLS, MSDP
• O—OSPF
• P—PIM
• R—RIP, RIPng
• S—Static
• T—Tunnel
P
Preference value of the route. In every routing metric except for the BGP LocalPref attribute, a lesser
value is preferred. In order to use common comparison routines, Junos OS stores the 1's complement
of the LocalPref value in the Preference2 field. For example, if the LocalPref value for Route 1 is 100,
the Preference2 value is -101. If the LocalPref value for Route 2 is 155, the Preference2 value is -156.
Route 2 is preferred because it has a higher LocalPref value and a lower Preference2 value.
Prf
Copyright © 2017, Juniper Networks, Inc.3154
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English