Juniper ACX2000 Configuration Guide

Table 75 on page 1063 describes the match conditions you can configure at the [edit firewall
family mpls filter filter-name term term-name from] hierarchy level.
Table 75: Standard Firewall Filter Match Conditions for MPLS Traffic on ACX Series Routers
DescriptionMatch Condition
Experimental (EXP) bit number or range of bit numbers in the MPLS header. For number, you
can specify one or more values from 0 through 7 in decimal, binary, or hexadecimal format.
exp number
Related
Documentation
Guidelines for Configuring Firewall Filters on page 1044•
• Standard Firewall Filter Match Conditions and Actions on ACX Series Routers Overview
on page 1052
• Standard Firewall Filter Terminating Actions on ACX Series Routers on page 1063
• Standard Firewall Filter Nonterminating Actions on ACX Series Routers on page 1064
Standard Firewall Filter Terminating Actions on ACX Series Routers
Standard stateless firewall filters support different sets of terminating actions for each
protocol family.
NOTE: ACX Series routers do not support the next term action.
Table 76 on page 1063 describes the terminating actions you can specify in a standard
firewall filter term.
Table 76: Terminating Actions for Standard Firewall Filters on ACX Series Routers
ProtocolsDescription
Terminating
Action
•
family any
•
family inet
•
family mpls
•
family ccc
Accept the packet.accept
•
family any
•
family inet
•
family mpls
•
family ccc
Discard a packet silently, without sending an Internet Control Message Protocol
(ICMP) message. Discarded packets are available for logging and sampling.
discard
1063Copyright © 2017, Juniper Networks, Inc.
Chapter 32: Configuring Firewall Filters

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English