Juniper ACX2000

Example: Configuring Two Addresses on the Loopback Interface with Subnetwork Routes
To configure two addresses on the loopback interface with subnetwork routes:
[edit]
user@host# edit interfaces lo0 unit 0 family inet
[edit interfaces lo0 unit 0 family inet]
user@host# set address 192.16.0.1/24
[edit interfaces lo0 unit 0 family inet]
user@host# set address 10.2.0.1/16
[edit interfaces lo0 unit 0 family inet]
user@host# top
[edit]
user@host# show
interfaces {
lo0 {
unit 0 {
family inet {
10.2.0.1/16;
127.0.0.1/32;
192.16.0.1/24;
}
}
}
}
Example: Configuring an IPv4 and an IPv6 Address on the Loopback Interface with Subnetwork
Routes
To configure an IPv4 and an IPv6 address on the loopback interface with subnetwork
routes:
[edit]
user@host# edit interfaces lo0 unit 0 family inet
[edit interfaces lo0 unit 0 family inet]
user@host# set address 192.16.0.1/24
[edit interfaces lo0 unit 0 family inet]
user@host# up
[edit interfaces lo0 unit 0 family]
user@host# edit interfaces lo0 unit 0 family inet6
[edit interfaces lo0 unit 0 family inet6]
user@host# set address 3ffe::1:200:f8ff:fe75:50df/64
[edit interfaces lo0 unit 0 family inet6]
user@host# top
[edit]
user@host# show
interfaces {
lo0 {
unit 0 {
family inet {
127.0.0.1/32;
192.16.0.1/24;
}
family inet6 {
103Copyright © 2017, Juniper Networks, Inc.
Chapter 4: Configuring Interfaces and Chassis