Juniper ACX2000

2. Configure the transparent clock.
[edit protocols ptp]
user@host# set e2e-transparent
3. Configure the interface for slave clock. For information on configuring PTP slave clock
interface, see “Configuring a PTP Slave Clock” on page 254.
[edit protocols ptp]
user@host# set slave interface interface-name...
Enabling PHY Timestamping for Boundary Clock
The following procedure enables you to configure PHY timestamping for boundary clock
in ACX:
NOTE: PHY timestamping is supported only on ACX500 line of routers.
1. Configure the clock mode as boundary.
[edit protocols ptp]
user@host# set clock-mode boundary
2. Configure the transparent clock.
[edit protocols ptp]
user@host# set e2e-transparent
3. Configure the interface for slave clock. For information on configuring PTP slave clock
interface, see “Configuring a PTP Slave Clock” on page 254.
[edit protocols ptp]
user@host# set slave interface interface-name...
4. Configure the interface for master clock. For information on configuring PTP master
boundary clock, see “Configuring a PTP Master Boundary Clock” on page 244.
[edit protocols ptp]
user@host# set master interface interface-name...
Enabling PHY Timestamping for Grandmaster Clock
The following procedure enables you to configure PHY timestamping for grandmaster
clock in ACX:
NOTE: In ACX Series routers, the grandmaster functionality is supported only
on ACX500 router.
1. Configure the clock mode as ordinary.
Copyright © 2017, Juniper Networks, Inc.272
ACX Series Universal Access Router Configuration Guide