EasyManuals Logo

Juniper ACX2000 Configuration Guide

Juniper ACX2000
3270 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #955 background imageLoading...
Page #955 background image
forwarding-class class-name statement at the [edit class-of-service interface
interface-name unit logical-unit-number hierarchy level.
Related
Documentation
Configuring Fixed Classification on an ATM IMA Pseudowire on page 897
Configuring Policing on an ATM IMA Pseudowire on page 912
Configuring Shaping on an ATM IMA Pseudowire on page 901
Configuring Fixed Classification on an ATM IMA Pseudowire
You configure fixed classification on the ATM IMA pseudowire logical interface (unit) by
specifying a forwarding class, which is applied to all packets received by the logical
interface. To complete this configuration, you can define a forwarding class at the [edit
class-of-service forwarding-classes] hierarchy level. If you do not define a forwarding
class, the default class is used.
The following steps require you to navigate various levels in the configuration hierarchy.
For information about navigating the CLI, see Using the CLI Editor in Configuration Mode
in the CLI User Guide.
NOTE: CoS fixed classification on an ATM IMA pseudowire is not applicable
on ACX5048 and ACX5096 routers.
To configure CoS fixed classification on an ATM IMA pseudowire:
1. Define the ATM IMA pseudowire. For information about defining the ATM IMA
pseudowire, see “Configuring Inverse Multiplexing for ATM (IMA)” on page 185.
2. In configuration mode, go to the [edit class-of-service] hierarchy level:
[edit]
user@host# edit class-of-service
3. Define the forwarding class to apply to the input logical interface, if the default
forwarding class is not used:
[edit class-of-service]
user@host# set forwarding-classes class class-name queue-num queue-num
4. Specify the ATM IMA interface on which to include the forwarding class:
[edit class-of-service]
user@host# edit interfaces at-fpc/pic/port
5. Configure the logical unit:
[edit class-of-service interfaces at-fpc/pic/port]
user@host# edit unit logical-unit-number
897Copyright © 2017, Juniper Networks, Inc.
Chapter 27: Configuring Class of Service

Table of Contents

Other manuals for Juniper ACX2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper ACX2000 and is the answer not in the manual?

Juniper ACX2000 Specifications

General IconGeneral
BrandJuniper
ModelACX2000
CategoryNetwork Router
LanguageEnglish

Related product manuals