To Next Page

To Previous Page

After you partition the DS interface, configure CESoPSN options on it. See “Setting the

CESoPSN Options” on page 216.

Configuring CESoPSN on DS Interfaces

To configure CESoPSN encapsulation on a DS interface, include the encapsulation

statement at the [edit interfaces ds-mpc-slot/mic-slot/port-number:channel] hierarchy

level.

1. In configuration mode, go to the [edit interfaces

ds-mpc-slot/mic-slot/port-number:channel] hierarchy level.

[edit]

user@host# edit interfaces ds-mpc-slot/mic-slot/ port-number:channel

For example:

[edit]

user@host# edit interfaces ds-1/0/0:1

2. Configure CESoPSN as the encapsulation type.

[edit interfaces ds-mpc-slot/mic-slot/port-number:partition ]

user@host# set encapsulation cesopsn

For example:

[edit interfaces ds-1/0/0:1 ]

user@host# set encapsulation cesopsn

3. Configure the logical interface for the DS interface.

[edit interfaces ds-mpc-slot/mic-slot/port-number:partition ]

uset@host# set unit interface-unit-number

For example:

[edit interfaces ds-1/0/0:1 ]

user@host# set unit 0

To verify this configuration, use the show command at the [edit interfaces ds-1/0/0:1]

hierarchy level.

[edit interfaces ds-1/0/0:1]

user@host# show

encapsulation cesopsn;

unit 0;

Documentation

• 16-Port Channelized E1/T1 Circuit Emulation MIC Overview on page 106

ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Configuration Guide

Other manuals for Juniper ACX2000