For example:
[edit interfaces coc3-1/0/0]
user@host# up
4. Configure the channelized OC1 interface and the sublevel interface partition index,
and set the interface type as ct1.
[edit interfaces]
user@host# set coc1-1/0/0:1 partition partition-number interface-type ct1
For example:
[edit interfaces]
user@host# set coc1-1/0/0:1 partition 1 interface-type ct1
To verify the configuration, use the show command at the [edit interfaces] hierarchy
level.
[edit interfaces]
user@host# show
coc3-1/0/0 {
partition 1 oc-slice 1 interface-type coc1;
}
coc1-1/0/0:1 {
partition 1 interface-type ct1;
}
Configuring CT1 Channels Down to DS Interfaces
To configure CT1 channels down to a DS interface, include the partition statement at the
[edit interfaces ct1-mpc-slot/mic-slot/port-number:channel:channel] hierarchy level:
1. In configuration mode, go to the [edit interfaces
ct1-mpc-slot/mic-slot/port-number:channel:channel] hierarchy level.
[edit]
user@host# edit interfaces ct1-mpc-slot/mic-slot/port-number:channel:channel
For example:
[edit]
user@host# edit interfaces ct1-1/0/0:1:1
2. Configure the partition, the time slots, and the interface type.
[edit interfaces ct1-mpc-slot/mic-slot/port-number:channel:channel]
user@host# set partition partition-number timeslots timeslots interface-type ds
For example:
[edit interfaces ct1-1/0/0:1:1]
user@host# set partition 1 timeslots 1-4 interface-type ds
209Copyright © 2017, Juniper Networks, Inc.
Chapter 8: Configuring CESoPSN Support on Interfaces
To Next Page
General
