Juniper ACX2000 Configuration Guide

Table 101: jjnxSoamPmNotificationObj Table (continued)
DescriptionObject IDObject
Denotes the suspect flag for the current
Measurement Interval in which the
notification was generated from the
jnxSoamLmCurrentStatsTable, or
jnxSoamDmCurrentStatsTable. This
object is only used for the notification.
jnxSoamPmNotificationObj 5jnxSoamPmNotificationObjSuspect
Denotes the Notification Crossing Type
of the object that caused the generation
of the notification from the
jnxSoamLmThresholdEntry or
jnxSoamDmThresholdEntry.
aboveAlarm(1)—Indicates that the
crossing type alarm was an above
threshold
setAlarm(2)—Indicates that the crossing
type alarm was a set threshold
clearAlarm(3)—Indicates that the
crossing type alarm was a clear threshold
This object is only used for the
notification.
jnxSoamPmNotificationObj 6jnxSoamPmNotificationObjCrossingType
Denotes the MAC address of the
Destination MEP associated the
notification found in either the
jnxSoamDmCfgTable or
jnxSoamLmCfgTable. This object is only
used for the notification.
jnxSoamPmNotificationObj 7jnxSoamPmNotificationObjDestinationMep
Denotes the CoS priority of the
associated notification found in either the
jnxSoamDmCfgTable or
jnxSoamLmCfgTable. This object is only
used for the notification.
jnxSoamPmNotificationObj 8jnxSoamPmNotificationObjPriority
Managed Objects for jnxSoamPmNotifications Table
The jnxSoamPmNotifications table, whose object identifier is {jnxSoamPmMib 0}, contains
the objects listed in the following table.
1227Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English