show route advertising-protocol
Syntax show route advertising-protocol protocol neighbor-address
<brief | detail | extensive | terse>
<logical-system (all | logical-system-name)>
Release Information Command introduced before Junos OS Release 7.4.
Description Display the routing information as it has been prepared for advertisement to a particular
neighbor of a particular dynamic routing protocol.
Options brief | detail | extensive | terse—(Optional) Display the specified level of output.
logical-system (all | logical-system-name)—(Optional) Perform this operation on all
logical systems or on a particular logical system.
neighbor-address—Address of the neighboring router to which the route entry is being
transmitted.
protocol—Protocol transmitting the route:
• bgp—Border Gateway Protocol
• dvmrp—Distance Vector Multicast Routing Protocol
• msdp—Multicast Source Discovery Protocol
• pim—Protocol Independent Multicast
• rip—Routing Information Protocol
• ripng—Routing Information Protocol next generation
Additional Information Routes displayed are routes that the routing table has exported into the routing protocol
and that have been filtered by the associated protocol's export routing policy statements.
Starting with Junos OS Release 13.3, you can display the routing instance table foo for
any address family, on a VPN route reflector, or a VPN AS boundary router that is
advertising local VPN routes. However, If you do not specify the table in the command,
the output displays each VRF prefix twice.
Required Privilege
Level
view
Related
Documentation
Example: Configuring the MED Attribute That Determines the Exit Point in an AS•
List of Sample Output show route advertising-protocol bgp (Layer 3 VPN) on page 2980
show route advertising-protocol bgp detail on page 2980
show route advertising-protocol bgp detail (Labeled Unicast) on page 2980
2977Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
