Juniper ACX2000

alarm (chassis)
Syntax alarm {
interface-type {
alarm-name (ignore |red | yellow);
}
}
Hierarchy Level [edit chassis],
[edit chassis interconnect-device name],
[edit chassis node-group name]
Release Information Statement introduced before Junos OS Release 7.4.
Statement introduced in Junos OS Release 11.1 for the QFX Series.
Statement introduced in Junos OS Release 12.2 for the ACX Series.
Statement introduced in Junos OS Release 14.1X53-D20 for the OCX Series.
Description Configure the chassis alarms and whether they trigger a red or yellow alarm, or whether
they are ignored. Red alarm conditions light the RED ALARM LED on either the router’s
craft interface or the switch’s LCD screen and trigger an audible alarm if one is connected
to the contact on the craft interface or LCD screen. Yellow alarm conditions light the
YELLOW ALARM LED on either the router’s craft interface or the switch’s LCD screen and
trigger an audible alarm if one is connected to the craft interface or LCD screen.
To configure more than one alarm, include multiple alarm-name lines.
Options alarm-name—Alarm condition. For a list of conditions, see System-Wide Alarms and Alarms
for Each Interface Type.
ignore—The specified alarm condition does not set off any alarm.
interface-type—Type of interface on which you are configuring the alarm: atm, ethernet,
sonet, or t3.
red—The specified alarm condition sets off a red alarm.
yellow—The specified alarm condition sets off a yellow alarm.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• Understanding Alarms
• Chassis Conditions That Trigger Alarms
• Chassis Alarm Messages on a QFX3500 Device
• Interface Alarm Messages
1427Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements