Juniper ACX2000 Configuration Guide

Table 13: CLI Equivalents of Terms Used in Documentation for an ACX5048 Router (continued)
Additional InformationItem in Documentation
Value (as displayed
in the CLI)
Description (as
displayed in the CLI)
Hardware
Item (as
displayed in
the CLI)
Interface Naming Conventions
Used in the Junos OS
Operational Commands
The router does not have
actual FPCs. In this case,
FPC refers to the router
itself.
Value of n is always 0.Abbreviated name of
the Flexible PIC
Concentrator (FPC)
FPC (n)
Interface Naming Conventions
Used in the Junos OS
Operational Commands
The router does not have
actual PIC devices; see
entries for PIC 0 for the
equivalent item on the
router.
Value of n is always 0.Abbreviated name of
the Physical Interface
Card (PIC)
PIC (n)
ACX5000 Universal Access
Router Overview
Built-in network ports on
the front panel of the
router
PIC 048x10G–6x40G
Port and Interface SpecificationsOptical transceiversn is a value equivalent
to the number of the
port in which the
transceiver is
installed.
Abbreviated name of
the transceiver
Xcvr (n)
AC Power Supply for an
ACX5000 Router
DC Power Supply for an
ACX5000 Router
AC power supply
DC power supply
n is a value in the
range of 0-1.
Power supplyPower
supply (n)
Cooling System and Airflow in
an ACX5000 Router
Fann is a value in the
range of 0-4.
FanFan
Figure 12: ACX5048 Interface Port Mapping
g0008 0 9
1 2
3
3—1— 40 Gigabit Ethernet ports (6)Electrostatic Discharge (ESD) terminal
2—10 Gigabit Ethernet ports (48)
ACX5096 Router Hardware and CLI Terminology Mapping
Table 14 on page 41 describes the hardware terms used in an ACX5096 router
documentation and the corresponding terms used in the Junos OS command line interface
(CLI). Figure 13 on page 41 shows the port locations of the interfaces.
Copyright © 2017, Juniper Networks, Inc.40
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English