Juniper ACX2000

user@host> monitor ethernet synthetic-loss-measurement 00:05:85:73:39:4a
maintenance-domain md6 maintenance-association ma6 count 10
ETH-SLM request to 00:05:85:73:39:4a, interface ge-1/0/0.0
Synthetic Loss measurement statistics:
SLM packets sent : 100
SLR packets received : 100
Accumulated SLM statistics:
Local TXFC1 value : 100
Local RXFC1 value : 100
Last Received SLR frame TXFCf(tc) : 100
Last Received SLR frame TXFCb(tc) : 100
SLM Frame Loss:
Frame Loss (far-end) : 0 (0.00 %)
Frame Loss (near-end) : 0 (0.00 %)
NOTE: If you attempt to monitor delays to a nonexistent MAC address, you
must press Ctrl + C to explicitly quit the monitor ethernet
synthetic-loss-measurement command and return to the CLI command
prompt.
Related
Documentation
Ethernet Synthetic Loss Measurement Overview on page 1140•
• Transmission of ETH-SLM Messages on page 1141
• Format of ETH-SLM Messages on page 1144
• Guidelines for Configuring ETH-SLM on page 1146
• Scenarios for Configuration of ETH-SLM on page 1147
• Managing ETH-SLM Statistics and ETH-SLM Frame Counts on page 1148
• Starting a Proactive ETH-SLM Session on page 1153
• Troubleshooting Failures with ETH-SLM
• Ethernet Interfaces Feature Guide for Routing Devices
Dynamic Ternary Content Addressable Memory Overview
•
Understanding Dynamic Ternary Content Addressable Memory on page 1157
•
Applications using Dynamic TCAM Infrastructure on page 1158
•
Features Using TCAM Resource on page 1158
•
Monitoring TCAM Resource Usage on page 1161
•
Example: Monitoring and Troubleshooting the TCAM Resource on page 1162
Understanding Dynamic Ternary Content Addressable Memory
In ACX Series routers, Ternary Content Addressable Memory (TCAM) is used by various
applications like firewall, connectivity fault management, PTPoE, RFC 2544, etc. The
Packet Forwarding Engine (PFE) in ACX Series routers uses TCAM with defined TCAM
1157Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)