6. Apply the forwarding class to the logical interface:
[edit class-of-service interfaces at-fpc/pic/port unit logical-unit-number]
user@host# set forwarding-class class-name
After you have configured fixed classification, enter the commit command in configuration
mode.
Related
Documentation
Understanding CoS on ATM IMA Pseudowire Interfaces Overview on page 895•
• Example: Configuring Fixed Classification on an ATM IMA Pseudowire on page 898
• Configuring Policing on an ATM IMA Pseudowire on page 912
• Configuring Shaping on an ATM IMA Pseudowire on page 901
Example: Configuring Fixed Classification on an ATM IMA Pseudowire
This example shows the configuration of fixed classification on an ATM IMA pseudowire.
Fixed classification is configured on the logical interface (unit) of the ATM IMA pseudowire.
The software assigns the fixed classification to packets on the basis of the fixed
classification parameters associated with the logical interface on which the ATM cells
are received.
NOTE: This example is not applicable on ACX5048 and ACX5096 routers.
•
Requirements on page 898
•
Overview on page 898
•
Configuration on page 899
Requirements
This example uses the following hardware and software components:
•
ACX Series router
•
Junos OS Release 12.2 or later
•
A previously configured ATM IMA pseudowire. For steps to configure an ATM IMA
pseudowire, see “Configuring Inverse Multiplexing for ATM (IMA)” on page 185.
Overview
In this example, the configured forwarding class fc-1 is applied to all packets received on
the ingress logical interface at-0/0/16 unit 0. The fixed classification classifies all traffic
on the logical interface unit zero (0) to queue-num 1.
Copyright © 2017, Juniper Networks, Inc.898
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
