To Next Page

To Previous Page

Power consumed : 0.0 W

Class of power device : 0

Documentation

Understanding PoE on ACX Series Universal Access Routers on page 142•

Configuring a Service Package to be Used in Conjunction with PTP

On ACX1100 routers, you can configure a service package on the router for the RFC

2544-based benchmarking test, or for NAT and IPsec applications. When you configure

the service package for the RFC 2544-based benchmarking test or for the NAT and IPsec

applications, a reboot of the Forwarding Engine Board (FEB) occurs to apply the service

package selection. By default, the service package for RFC 2544 benchmarking test is

selected. The selection of a service package is needed on ACX1100 routers when you

configure such routers for IEEE 1588v2 Precision Time Protocol (PTP) because both RFC

2544-based benchmarking tests and a combination of NAT and IPsec protocols are not

supported simultaneously; you can configure only PTP and RFC 2544-based tests, or

PTP and the combination of NAT and IPsec at a point in time.

You need to specify the service package to be RFC 2544-based or NAT and IPsec-based

only for ACX1100-AC routers. The selection of a service package is not needed on ACX

Series routers other than the ACX1100-AC and ACX500 routers because on such routers,

only the RFC 2544-based benchmarking tests are supported; NAT and IPsec applications

are not supported on those routers.

To configure the RFC 2544-based service package on a particular FPC, include the

service-package bundle-rfc2544 statement at the [edit chassis fpc slot-number] hierarchy

level.

[edit chassis]

fpc slot-number {

service-package bundle-rfc2544;

}

To configure the NAT and IPsec applications service package on a particular FPC, include

the service-package bundle-nat-ipsec statement at the [edit chassis fpc slot-number]

hierarchy level.

[edit chassis]

fpc slot-number {

service-package bundle-nat-ipsec;

}

Documentation

service-package on page 1714•

Checklist for Monitoring Fast Ethernet and Gigabit Ethernet Interfaces

Purpose To monitor Fast Ethernet and Gigabit Ethernet interfaces and begin the process of isolating

interface problems when they occur.

ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Configuration Guide

Other manuals for Juniper ACX2000