dscp (rewrite-name | default);
dscp-ipv6 (rewrite-name | default);
exp (rewrite-name | default) protocol protocol-types;
ieee-802.1 (rewrite-name | default) vlan-tag (outer | outer-and-inner);
inet-precedence (rewrite-name | default);
}
}
}
The following CLI statements are not applicable to ACX Series Universal Access Routers.
[edit class-of-service routing-instances routing-instance-name]
[edit class-of-service scheduler-map-chassis map-name]
[edit class-of-service interfaces interface-name unit logical-unit-number]
input-shaping-rate (percent percentage | rate);
input-traffic-control-profile profiler-name shared-instance instance-name;
output-traffic-control-profile profile-name shared-instance instance-name;
per-session-scheduler;
scheduler-map map-name;
shaping-rate rate;
[edit class-of-service interfaces iinterface-name unit logical-unit-number]
classifiers {
type (classifier-name | default);
}
rewrite-rules {
dscp (rewrite-name | default);
dscp-ipv6 (rewrite-name | default);
exp (rewrite-name | default) protocol protocol-types;
exp-push-push-push default;
exp-swap-push-push default;
ieee-802.1 (rewrite-name | default) vlan-tag (outer | outer-and-inner);
inet-precedence (rewrite-name | default);
}
In the above stanza, [edit class-of-service interface-name unit logical-unit-number
rewrite-rule exp (rewrite-name | default)] is supported. However, edit [class-of-service
interface-name unit logical-unit-number rewrite-rule exp protocol protocol type] is not
supported.
[edit class-of-service interfaces interface-name interface-set interface-set-name]
excess-bandwidth-share;
internal-node;
output-traffic-control-profile profile-name;
output-traffic-control-profile-remaining profile-name;
Related
Documentation
CoS on ACX Series Universal Access Routers Features Overview on page 864•
• Configuring CoS on ACX Series Universal Access Routers on page 866
Configuring CoS on ACX Series Universal Access Routers
Physical interface-based classifiers are supported at the [edit class-of-service interfaces
interfaces-name] hierarchy level. EXP bits are located in each MPLS label and used to
Copyright © 2017, Juniper Networks, Inc.866
ACX Series Universal Access Router Configuration Guide