show protection-group ethernet-ring node-state
Syntax show protection-group ethernet-ring node-state
Release Information Command introduced in Junos OS Release 9.4 for MX Series routers.
Command introduced in Junos OS Release 12.1 for EX Series switches.
Command introduced in Junos OS Release 12.3X54 for ACX Series routers.
Description Display the status of the Automatic Protection Switching (APS) nodes on an Ethernet
ring.
Options This command has no options.
Required Privilege
Level
view
Related
Documentation
show protection-group ethernet-ring data-channel•
• show protection-group ethernet-ring aps on page 2916
• show protection-group ethernet-ring interface on page 2920
• show protection-group ethernet-ring statistics on page 2927
• show protection-group ethernet-ring vlan on page 2932
List of Sample Output show protection-group ethernet-ring node-state (MX Series Router - RPL Owner Node,
Normal Operation) on page 2925
show protection-group ethernet-ring node-state (MX Series Router - Normal Ring
Node, Normal Operation) on page 2925
show protection-group ethernet-ring node-state (MX Series Router - RPL Owner Node,
Remote Failure Condition) on page 2925
show protection-group ethernet-ring node-state detail (ACX Series and MX Series
Router) on page 2925
show protection-group ethernet-ring node-state detail (MX Series Router - RPL Owner
Node, Normal Operation) on page 2925
Output Fields Table 204 on page 2923 lists the output fields for the show protection-group ethernet-ring
node-state command. Output fields are listed in the approximate order in which they
appear.
Table 204: show protection-group ethernet-ring node-state Output Fields
Field DescriptionField Name
Name configured for the Ethernet ring.Ring Name/Ethernet Ring
2923Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
