reflect-mode (RFC2544 Benchmarking)
Syntax reflect-mode (mac-rewrite | mac-swap | no-mac-swap );
Hierarchy Level [edit services rpm rfc2544-benchmarkingtests test-name test-name]
Release Information Statement introduced in Junos OS Release 12.3X52 for ACX Series routers.
Statement introduced in Junos OS Release 14.2 for MX104 3D Universal Edge routers.
Description Specify the reflection mode for the benchmarking test.
Options mac-rewrite—(ACX Series routers only) Enable rewriting of the MAC address on the
reflected frames. The MAC addresses specified in the source-mac-address and
destination-mac-address options are used.
mac-swap—Swap the source and destination MAC addresses in the test frame. This is
the default behavior.
NOTE: In bridge families, when the service type is ELAN, MAC addresses
are swapped by default, on the reflected frames. And, when the service
type is ELINE , MAC addresses are not swapped by default.
no-mac-swap—Do not swap the source and destination MAC addresses in the test frame.
The frame is returned to the originator without any modification to the MAC
addresses.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• RFC2544-Based Benchmarking Tests for E-LAN and E-Line Services Overview
• rfc2544-benchmarking on page 1698
• RFC2544-Based Benchmarking Tests Overview
• Configuring an RFC 2544-Based Benchmarking Test
1697Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements
To Next Page
Loading...
Need help?
General
