To Next Page

To Previous Page

inet6-vpn

Syntax inet6-vpn (any | multicast | unicast) {

aggregate-label;

prefix-limit maximum;

rib-group rib-group-name;

}

Hierarchy Level [edit logical-systems logical-system-name protocols bgp family],

[edit logical-systems logical-system-name protocols bgp group group-name family],

[edit protocols bgp family],

[edit protocols bgp group group-name family]

Release Information Statement introduced before Junos OS Release 7.4.

Statement introduced in Junos OS Release 11.3 for QFX Series switches.

Description Enable IP version 6 (IPv6) on the provider edge (PE) router for the Layer 3 VPN.

NOTE: The [edit logical-systems] hierarchy level is not applicable in ACX

Series routers.

Options any—Configure the family type to be both multicast and unicast.

multicast—Configure the family type to be multicast. This means that the BGP peers are

being used only to carry the unicast routes that are being used by multicast for

resolving the multicast routes.

prefix-limit maximum—Maximum prefix limit.

Range: 1 through 4,294,967,295

Default: 1

rib-group rib-group-name—The name of the routing table group.

unicast—Configure the family type to be unicast. This means that the BGP peers only

carry the unicast routes that are being used for unicast forwarding purposes.

Required Privilege

Level

routing—To view this statement in the configuration.

routing-control—To add this statement to the configuration.

Documentation

• Configuring Layer 3 VPNs to Carry IPv6 Traffic on page 844

• Junos OS Routing Protocols Library

ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Configuration Guide

Other manuals for Juniper ACX2000