show route extensive
List of Syntax Syntax on page 3025
Syntax (EX Series Switches) on page 3025
Syntax show route extensive
<destination-prefix>
<logical-system (all | logical-system-name)>
Syntax (EX Series
Switches)
show route extensive
<destination-prefix>
Release Information Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
Description Display extensive information about the active entries in the routing tables.
Options none—Display all active entries in the routing table.
destination-prefix—(Optional) Display active entries for the specified address or range
of addresses.
logical-system (all | logical-system-name)—(Optional) Perform this operation on all
logical systems or on a particular logical system.
Required Privilege
Level
view
List of Sample Output show route extensive on page 3032
show route extensive (Access Route) on page 3039
show route extensive (BGP PIC Edge) on page 3039
show route extensive (FRR and LFA) on page 3040
show route extensive (IS-IS) on page 3041
show route extensive (Route Reflector) on page 3041
show route label detail (Multipoint LDP Inband Signaling for Point-to-Multipoint
LSPs) on page 3041
show route label detail (Multipoint LDP with Multicast-Only Fast Reroute) on page 3042
Output Fields Table 221 on page 3025 describes the output fields for the show route extensive command.
Output fields are listed in the approximate order in which they appear.
Table 221: show route extensive Output Fields
Field DescriptionField Name
Name of the routing table (for example, inet.0).routing-table-name
Number of destinations for which there are routes in the routing table.number destinations
3025Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
