Juniper ACX2000

synchronization (ACX Series)
Syntax synchronization {
clock-mode (auto-select | free-run);
esmc-transmit {
interfaces (all | interface-name);
}
hold-interval {
configuration-change seconds;
restart seconds;
switchover seconds;
}
interfaces bits {
signal-type (2048KHZ | e1 | t1) {
e1-options {
framing (g704 | g704-no-cro4);
}
t1-options {
framing (esf | sf);
}
}
}
network-option (option-1 | option-2);
quality-mode-enable;
selection-mode (configured-quality | received-quality);
source {
(bits | gps) {
priority number;
quality-level (prc | prs |sec | smc | ssu-a | ssu-b | st2 | st3 | st3e | st4 | stu | tnc);
request (force-switch | lockout);
}
interfaces interface-name {
priority number;
quality-level (prc | prs |sec | smc | ssu-a | ssu-b | st2 | st3 | st3e | st4 | stu | tnc);
request (force-switch | lockout);
wait-to-restore minutes;
}
}
switchover-mode(non-revertive | revertive);
}
Hierarchy Level [edit chassis]
Release Information Statement introduced in Junos OS Release 12.2 for ACX Series Routers.
Description Configure Synchronous Ethernet parameters.
Options The remaining statements are explained separately. See CLI Explorer.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
1739Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements