Juniper ACX2000

clock-mode
Syntax clock-mode (boundary | ordinary);
Hierarchy Level [edit protocols ptp]
Release Information Statement introduced in Junos OS Release 12.2.
Statement introduced in Junos OS Release 12.2 for the ACX Series Universal Access
Routers.
Description Configure the clock mode as either boundary clock or ordinary clock. The clock mode
determines whether the node is going to act as a slave, master, or both. This attribute is
mandatory and has no default value.
Options boundary—The clock mode of the node is a boundary clock where the clock acts as both
master and slave.
NOTE: A boundary clock is not supported on the ACX Series routers for 12.2.
ordinary—The clock mode of the node is a system clock where the clock acts either as a
master or as a slave.
Required Privilege
Level
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Related
Documentation
• Configuring Precision Time Protocol
• Example: Configuring Precision Time Protocol
• Precision Time Protocol Overview
• IEEE 1588v2 Precision Timing Protocol (PTP) on ACX Series Universal Access Routers
on page 237
1465Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements