Juniper ACX2000 Configuration Guide

CHAPTER 25
Configuring Layer 2 and Layer 3 Services
•
Configuring Interfaces for Layer 2 Circuits Overview on page 774
•
Configuring the Address for the Neighbor of the Layer 2 Circuit on page 774
•
Configuring the Neighbor Interface for the Layer 2 Circuit on page 774
•
Configuring a Community for the Layer 2 Circuit on page 775
•
Configuring the Control Word for Layer 2 Circuits on page 775
•
Configuring the Encapsulation Type for the Layer 2 Circuit Neighbor Interface on page 777
•
Configuring the MTU Advertised for a Layer 2 Circuit on page 777
•
Configuring the Protect Interface on page 778
•
Configuring the Virtual Circuit ID on page 778
•
Configuring the Interface Encapsulation Type for Layer 2 Circuits on page 779
•
Configuring Layer 2 Circuits over Both RSVP and LDP LSPs on page 779
•
Enabling the Layer 2 Circuit When the MTU Does Not Match on page 780
•
Enabling the Layer 2 Circuit When the Encapsulation Does Not Match on page 780
•
Configuring Local Interface Switching in Layer 2 Circuits on page 781
•
Example: Configuring Layer 2 Circuit Switching Protection on page 783
•
Accepting Route Updates with Unique Inner VPN Labels in Layer 3 VPNs on page 785
•
Understanding Per-Packet Load Balancing on page 789
•
Configuring Per-Packet Load Balancing on page 790
•
Configuring Load Balancing Based on MPLS Labels on ACX Series Routers on page 793
•
Configuring Load Balancing for Ethernet Pseudowires on page 797
•
Configuring Load Balancing Based on MAC Addresses on page 798
•
ECMP Flow-Based Forwarding on ACX Series Routers on page 799
•
Sample Scenario of H-VPLS on ACX Series Routers for IPTV Services on page 800
•
Guidelines for Configuring Unicast RPF on ACX Series Routers on page 803
•
Configuring Unicast RPF on ACX Series Routers on page 804
•
Verifying Unicast RPF Status on page 808
773Copyright © 2017, Juniper Networks, Inc.

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English