Juniper ACX2000

vlan-id 500;
}
output-vlan-map pop;
}
}
The following is an example to configure a logical interface connected to a service provider
network:
[edit]
interface ge-1/0/2; {
flexible-vlan-tagging;
encapsulation flexible-ethernet-services;
unit 0 {
encapsulation vlan-bridge;
vlan-id 500;
}
}
The following is an example to configure the bridge domain:
[edit]
bridge-domains {
qnq-stag-500{
interface ge-1/0/1;
interface ge-1/0/2;
}
}
You can configure Q-in-Q tunneling on aggregated Ethernet interface connected to the
customer network (UNI) and the logical interface connected to the service provider
network (NNI).
Related
Documentation
• Layer 2 Bridge Domains on ACX Series Overview on page 755
• Q-in-Q Tunneling on ACX Series Overview on page 770
• Layer 2 Learning and Forwarding for Bridge Domains Overview on page 759
• Configuring a Bridge Domain on ACX Series Routers on page 760
• Configuring VLAN Identifiers for Bridge Domains in ACX Series on page 764
• Disabling MAC Learning for Bridge Domains on ACX Series on page 765
• Configuring Static MAC Addresses for Logical Interfaces in a Bridge Domain in ACX
Series on page 766
• Configuring the Size of the MAC Address Table for Bridge Domains in ACX Series on
page 766
Copyright © 2017, Juniper Networks, Inc.772
ACX Series Universal Access Router Configuration Guide