results of each category or state of the RFC 2544-based benchmarking test, such as
aborted tests, active tests, and completed tests, for each real-time performance
monitoring (RPM) instance.
Meaning The output displays the details of the benchmarking test that was performed. For more
information about the run show ptp clock operational command, see show services rpm
rfc2544-benchmarking in the CLI Explorer.
Related
Documentation
Configuring RFC 2544-Based Benchmarking Tests on page 1341•
• rfc2544-benchmarking on page 1698
• profiles on page 1678
• tests on page 1749
• show services rpm rfc2544-benchmarking on page 3156
• show services rpm rfc2544-benchmarking test-id on page 3161
Example: Configuring an RFC 2544-Based Benchmarking Test for NNI Direction of
Ethernet Pseudowires
This example shows how to configure the benchmarking test for a network-to-network
interface (NNI) direction of an Ethernet pseudowire service.
•
Requirements on page 1367
•
Overview on page 1367
•
Configuration on page 1368
•
Verifying the Results of the Benchmarking Test for NNI Direction of an Ethernet
Pseudowire Service on page 1374
Requirements
This example uses the following hardware and software components:
•
An ACX Series router
•
Junos OS Release 12.3X52 or later
Overview
Consider a sample topology in which a router, Router A, functions as an initiator and
terminator of the test frames for an RFC 2544-based benchmarking test. Router A
operates as a provider edge device, PE1, which is connected to a customer edge device,
CE1, on one side and over an Ethernet pseudowire to another router, Router B, which
functions as a reflector to reflect back the test frames it receives from Router A. Router
B operates as a provider edge device, PE2, which is the remote router located at the other
side of the service provider core. The UNI direction of CE1 is connected to the NNI direction
1367Copyright © 2017, Juniper Networks, Inc.
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests
To Next Page
Loading...
Need help?
General
