family (RFC 2544 Benchmarking)
Syntax family (inet | ccc | bridge);
Hierarchy Level [edit services rpm rfc2544-benchmarkingtests test-name test-name]
Release Information Statement introduced in Junos OS Release 12.3X53 for ACX Series routers.
The bridge option introduced in Junos OS Release 12.3X53 for ACX Series routers.
Description Configure the address type family for the benchmarking test.
Options inet—Indicates that the test is run on an IPv4 service.
NOTE: Family inet is not supported on ACX5048 and ACX5096 routers.
ccc—Indicates that the test is run on a circuit cross-connect (CCC) or Ethernet pseudowire
service. The direction option specifies the direction (ingress or egress) to be used for
the test.
bridge—Indicates that the test is run on a Layer 2 Ethernet line (E- LINE) or an Ethernet
LAN (ELAN) service configured in a bridge domain.
NOTE: Junos OS Release 12.3X53 for ACX Series routers support only
family bridge.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• RFC 2544-Based Benchmarking Tests Overview on page 1335
• Configuring RFC 2544-Based Benchmarking Tests on page 1341
• rfc2544-benchmarking on page 1698
Copyright © 2017, Juniper Networks, Inc.1514
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
