Juniper ACX2000 Configuration Guide

CHAPTER 34
Configuring Operations, Administration,
and Management (OAM)
•
Understanding Ethernet OAM Link Fault Management for ACX Series Routers on page 1112
•
Configuring Ethernet Local Management Interface on ACX Series on page 1113
•
Ethernet Frame Delay Measurements Overview on page 1117
•
Ethernet Frame Loss Measurement Overview on page 1121
•
Proactive Mode for SLA Measurement on page 1123
•
On-Demand Mode for SLA Measurement on page 1125
•
Configuring MEP Interfaces to Support Delay Measurement on page 1125
•
Ethernet OAM Connectivity Fault Management on page 1126
•
IEEE 802.1ag OAM Connectivity Fault Management in ACX Series Overview on page 1128
•
Configuring Maintenance Association Intermediate Points in ACX Series on page 1129
•
Example: Configuring IEEE 802.3ah OAM Support for an Interface on page 1133
•
Enabling Dying Gasp Functionality on page 1135
•
Ethernet Alarm Indication Signal Overview on page 1136
•
Configuring Alarm Indication Signal on ACX Series Routers on page 1138
•
Ethernet Synthetic Loss Measurement Overview on page 1140
•
Transmission of ETH-SLM Messages on page 1141
•
Format of ETH-SLM Messages on page 1144
•
Guidelines for Configuring ETH-SLM on page 1146
•
Scenarios for Configuration of ETH-SLM on page 1147
•
Managing ETH-SLM Statistics and ETH-SLM Frame Counts on page 1148
•
Starting a Proactive ETH-SLM Session on page 1153
•
Starting an On-Demand ETH-SLM Session on page 1156
•
Dynamic Ternary Content Addressable Memory Overview on page 1157
•
Service Scaling on ACX5048 and ACX5096 Routers on page 1167
•
Understanding Layer 2 Next Generation Mode on ACX5048 and ACX5096
Routers on page 1167
1111Copyright © 2017, Juniper Networks, Inc.

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English