Juniper ACX2000 Configuration Guide

Table 94: jnxSoamLmHistoryStatsTable (continued)
DescriptionObject IDObject
Contains the minimum one-way frame
loss ratio in the backward direction
calculated by this MEP for this
Measurement Interval. The FLR value is
a ratio that is expressed as a percent with
a value of 0 (ratio 0.00) through 100000
(ratio 1.00). Units are in milli-percent,
where 1 indicates 0.001 percent.
jnxSoamLmHistoryStatsEntry 12jnxSoamLmHistoryStatsBackwardMinFlr
Contains the maximum one-way frame
loss ratio in the backward direction
calculated by this MEP for this
Measurement Interval. The FLR value is
a ratio that is expressed as a percent with
a value of 0 (ratio 0.00) through 100000
(ratio 1.00). Units are in milli-percent,
where 1 indicates 0.001 percent.
jnxSoamLmHistoryStatsEntry 13jnxSoamLmHistoryStatsBackwardMaxFlr
Contains the average one-way frame loss
ratio in the backward direction calculated
by this MEP for this Measurement
Interval. The FLR value is a ratio that is
expressed as a percent with a value of 0
(ratio 0.00) through 100000 (ratio 1.00).
Units are in milli-percent, where 1
indicates 0.001 percent.
jnxSoamLmHistoryStatsEntry 14jnxSoamLmHistoryStatsBackwardAvgFlr
Contains the count of the number of
SOAM PDUs sent during this
Measurement Interval. This object applies
when jnxSoamLmCfgType is lmLmm,
lmSlm, or lmCcm. It indicates the number
of LMM, CCM, or SLM SOAM frames
transmitted.
jnxSoamLmHistoryStatsEntry 15jnxSoamLmHistoryStatsSoamPdusSent
Contains the count of the number of
SOAM PDUs received in this
Measurement Interval. This object applies
when jnxSoamLmCfgType is lmLmm,
lmSlm, or lmCcm. This object indicates
the number of LMR, CCM, or SLR SOAM
frames received.
jnxSoamLmHistoryStatsEntry 16jnxSoamLmHistoryStatsSoamPdusReceived
Managed Objects for jnxSoamDmCfgTable
The jnxSoamDmCfgTable, whose object identifier is {jnxSoamPmLmObjects 1}, contains
the jnxSoamDmCfgEntry that signifies the Ethernet loss measurement (ETH-DM)
configuration settings. Each jnxSoamDmCfgEntry, whose object identifier is
{jnxSoamDmCfgTable 1}, contains the objects listed in the following table.
The jnxSoamDmCfgTable includes configuration objects and operations for the Delay
Measurement function. Each row in the table represents a Delay Measurement session
1191Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English