Juniper ACX2000 Configuration Guide

Figure 3: ACX500 Indoor Router Interface Port Mapping—DC and AC
Chassis
ACX500-DC
0/1/30/1/0 PoE++ 0/1/1 PoE+ 0/1/2 PoE+
0/1/30/1/20/1/10/1/00/0/10/0/0
GE
COMBO
POWER
1 2
SYS
MGMT TOD CONSOLE
GPS 1PPS
GPS ANTENNA
IN
OUT ALARM
g000699
1 2 3
3—1—
FPC 0, PIC 1: 0/1/0 PoE++, 0/1/1 PoE+,
0/1/2 PoE+, and 0/1/3 (4x1GE RJ-45)
FPC 0, PIC 0: 0/0/0–0/0/1 (2x1GE SFP)
2—
FPC 0, PIC 1: 0/1/0–0/1/3 (4x1GE SFP)
ACX500 Outdoor Routers Hardware and CLI Terminology Mapping
Table 5 on page 27 describes the hardware terms used in ACX500 outdoor router
documentation and the corresponding terms used in the Junos OS CLI. Figure 4 on page 28
shows the port locations of the interfaces.
Table 5: CLI Equivalents of Terms Used in Documentation for ACX500 Outdoor Routers
Additional InformationItem in Documentation
Value (as
Displayed in the
CLI)
Description (as
Displayed in the CLI)
Hardware
Item (as
Displayed
in the CLI)
Chassis Physical Specifications
for ACX500 Routers
Router chassis–ACX500Chassis
Interface Naming Conventions
Used in the Junos OS
Operational Commands
The router does not have
actual FPCs. In this case,
FPC refers to the router
itself.
Value of n is always
0.
Abbreviated name of
the Flexible PIC
Concentrator (FPC)
FPC (n)
Interface Naming Conventions
Used in the Junos OS
Operational Commands
The router does not have
actual PIC devices; see
entries for PIC 0 through PIC
1 for the equivalent item on
the router.
n is a value in the
range of 0–1.
Abbreviated name of
the Physical Interface
Card (PIC)
PIC (n)
ACX500 Universal Access
Router Overview
Built-in uplink ports on the
front panel of the router
PIC 03x 1GE (SFP)
ACX500 Universal Access
Router Overview
Built-in uplink ports on the
front panel of the router
PIC 13x 1GE (RJ-45)
27Copyright © 2017, Juniper Networks, Inc.
Chapter 1: ACX Series Universal Access Router Overview

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English